Burst supply line, overflowing toilet, a storm that found the weak spot in your roof: whatever let the water in, the clock started when it did. One call to +1-323-329-3586 routes you to an independent restoration pro in Burleigh County who takes emergency calls around the clock.


Business Leak Detection is a referral service, not a contractor. We run a 24/7 phone line that connects people dealing with water damage to independent, licensed and insured restoration contractors who work in Burleigh County. You talk to a real person, describe what happened, and get routed to a pro who handles that kind of job.
The contractors in the network do this work every week: pulling standing water with truck-mounted extractors, setting air movers and dehumidifiers, reading moisture behind baseboards, and cutting out wet drywall before it becomes a mold job. They know a slab leak from a roof leak, and they price the job before they start.
Water damage rarely waits for business hours, so neither does the line. Nights, weekends, and holidays get the same response as a Tuesday morning, and if the first contractor is tied up, the call moves to the next one covering your part of the county.
Water does its worst work where nobody is looking. These are the signs restoration contractors say people tend to ignore until the repair bill doubles.
Below is the work contractors in the network handle most often. Tell the dispatcher which one fits, or just describe what you're seeing and they'll sort it out.
Standing water keeps soaking into drywall, subfloor, and framing for as long as it sits. Contractors arrive with truck-mounted or portable extraction units, pull water out of carpet and pad, and pump out flooded rooms so drying can start the same day.
Part of that first visit is classifying the loss: clean water from a supply line, gray water from an appliance, or contaminated Category 3 water. That call decides what can be dried in place and what has to go.
Homes take water from washing machine hoses, water heater failures, toilet supply lines, ice maker lines, and roof leaks. Residential contractors find the source, stop it, dry the structure, and then replace what can't be saved: drywall, baseboard, insulation, and flooring.
They'll photograph the damage, log readings room by room, and hand you paperwork your insurer can use if you decide to file.
A flooded office, retail floor, or restaurant kitchen costs money every hour it stays closed. Commercial restoration contractors scale up with more extractors, larger desiccant dehumidifiers, and crews that can work after hours so you can stay partly open.
They're used to working with property managers, building engineers, and multiple tenants, and they section off affected areas with containment so the rest of the building keeps running.
Removing visible water is half the job. Contractors set air movers to push air across wet surfaces and refrigerant or desiccant dehumidifiers to pull moisture out of the air, then check progress daily with moisture meters until materials reach dry standard.
Thermal imaging cameras help find wet pockets behind walls without tearing everything out, and small weep holes drilled behind the baseboard can dry a wall cavity without full demolition.
After drying, the contractor replaces whatever had to come out: ceiling panels, wall sections, insulation, trim, carpet pad, or hardwood. A lot of pros in the network do mitigation and rebuild both, which keeps one crew accountable start to finish.
A careful crew matches ceiling texture and paint sheen so the repaired area blends into the rest of the room.
Water from a sewer backup or rising floodwater is treated as contaminated. Crews suit up in protective gear, tear out porous materials that can't be cleaned, apply antimicrobial treatment, and dry the space under containment.
Keep everyone, especially children and pets, away from the affected area until it has been cleaned and disinfected by a pro.

Four steps, usually in the order below. The first one takes about two minutes.
Dial +1-323-329-3586 and tell the dispatcher what happened, where the water is, and whether it's still coming in. If you can safely shut off the main valve or breaker, do it first.
An independent contractor serving your area gets your details and confirms an arrival window. For active leaks and flooding, crews often arrive within the hour.
On site, the contractor traces the source, maps wet areas with meters and a thermal camera, and explains the scope and price before work starts.
The crew extracts water, sets drying equipment, and checks progress every day. Repairs come after the structure is confirmed dry, and the documentation stays with you.
You could search and call contractors one by one at 2 a.m. Here's why people call this line instead.

No vague estimates. The contractor explains scope and cost before any work begins, and changes get discussed with you first.
Emergency calls jump the queue. Arrival depends on traffic and weather, but crews commonly reach active leaks within roughly an hour.
You get matched with a contractor who serves your area regularly and knows the local housing stock, from slab homes to older basements.
The network is made up of independent contractors who carry the licensing and insurance the work calls for. Ask to see both when they arrive; a good contractor will show you without hesitation.
Photos, moisture maps, and drying logs give your adjuster the evidence they need, which can speed up a claim.
If the first match doesn't work out, call the line again and you'll be connected with a different contractor. A good match is the whole point of the service.

Water heater burst at midnight and flooded the laundry room. The crew was there within the hour, extracted everything, and came back daily to check moisture until the drywall read dry.
A supply line under our upstairs sink failed while we were at work, and part of the kitchen ceiling came down. The contractor walked us through the quote before touching anything and took all the photos our insurer wanted.
A sprinkler line broke in one of our suites over a weekend. The crew sealed it off, ran dehumidifiers through Sunday, and the rest of the building opened Monday as usual.
Our basement took water after a heavy storm. The contractor explained it was Category 3 because it came from outside, cut out the bottom two feet of drywall, treated everything, and it's stayed dry since.
A slow leak behind the shower had been rotting the subfloor for months. They found it with a thermal camera without tearing up the whole bathroom, dried it, and replaced the damaged section.
For active leaks and flooding, many contractors in the network arrive within about an hour. Exact timing depends on distance, traffic, and weather, and the dispatcher gives you an estimated window when you call.
The call itself is free. Pricing comes from the contractor, who assesses the job and explains the cost before any work begins.
Contractors handle emergency extraction, flood pumping, drying setup, sewage and Category 3 cleanup, and temporary protection like tarps, 24 hours a day.
No. Business Leak Detection is a free referral service. The work is done by independent local contractors, and you agree on price and scope directly with them.
It depends on the cause. Policies usually cover sudden events like a split supply line but often exclude slow leaks and floodwater without separate flood coverage. The contractor's photos and moisture logs help either way.
Typical drying runs about three to five days. Dense materials like hardwood and concrete slabs can need more time, which is why moisture readings, not the calendar, decide when it's done.
Stop the source at the main shutoff, kill the breaker for affected rooms if it's safe, lift furniture off wet carpet with foil or blocks, and photograph everything.
Box fans help a little with the surface, but they don't reach water trapped behind drywall or under flooring. That hidden moisture is where mold starts.
Under the right conditions, mold growth starts in one to two days. Getting materials dry quickly is the best prevention there is.
They do. Commercial calls for offices, stores, restaurants, and apartment buildings are routed to contractors with the larger equipment and crews those jobs need.
Yes. There's no charge to call or to be connected. You only pay the contractor for work you agree to.
Always. Contractors in the network are independent businesses, so ask for proof of licensing and insurance before work starts. A reputable pro will have it ready.
The network covers single-family homes, apartments, condos, townhomes, and commercial buildings in Burleigh County. Whether you're in a downtown high-rise or a house at the edge of the county, calls go to the closest available contractor.
Local knowledge matters here. A contractor who works your area knows whether homes usually sit on slabs, basements, or crawl spaces, and what that means for where water hides.
From the county seat out to unincorporated areas, contractors serving Burleigh County respond to homes, farms, and businesses alike. Rural properties on wells and septic systems get the same routing as in-town addresses.
Because drives across a county can run long, calls are matched by distance first. The nearest available contractor gets the job, which keeps arrival times down for outlying addresses.

Every hour counts on a water loss. Call +1-323-329-3586 and get routed to a licensed, insured independent contractor serving Burleigh County.
Reach a dispatcher this minuteCall +1-323-329-3586